MRV Communications TERESCOPE TS800/155 - Manual (Page 51)

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
41
Fig. 6.9: Telescope crosshair on the opposite TereScope
2. While looking (see fig 6.9 below) through the telescope, rotate and
tilt the TereScope to bring the telescope crosshairs on the left side
(your right side) of the opposite TereScope.
3. Tighten firmly 4 Bolts K and D in such a way that the aiming
anchors (L1&L2) will be between the screws C and B.
Fine Alignment
The purpose of fine alignment is to position the center of the transmitted
beam spot on the center of the TereScope receiver – in both directions (Fig
6.10). This is achieved by adjusting the horizontal and vertical motion screws
(shown in Figure 6.11) until maximum power is received at the opposite
TereScope.
Transceiver
Beam Cross Section
H1
H2
V2
V1
Figure 6.10: Front view – Transceiver at the middle of the beam cross section
Figure 6.11: Fine Alignment Motion Screws
Fine Alignment Vertical
Motion Screws
Fine Alignment
Horizontal Motion Screws