MRV Communications TERESCOPE TS800/155 - Manual (Page 49)

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
39
1 – Make sure that the power cable is disconnected
from the electrical power source.
2 – Undo the five screws H -- see Figure 6.1. Holding
the Rear Door, Pull the door, turn it clockwise ¼ of a
turn around the axis (I), so that a screw will be
opposite hole ”O”. Fixe the door on the hole ”O”
with the screw.
3 – Connect the wires of the power cable (see Figure 6.4)
to the Terminal Block (see Figure 6.5) paying attention to
L=Line, G=Ground & N=Neutral.
4 – After connecting the power cables to corresponding sockets,
tightly close the screws of the Terminal block –
see Figure 6.5. Gently jerk the cable to check that it stays connected.
Cover the Terminal Block with a plastic cover (if available).
Fig. 6.5: Power Terminal Block Locked
6 – Rotate and push the Back Door up, and tighten
the five H screws.
7 – Connect the power cable to the electrical power
source to power on the TereScope.
Captive
Screws H
5 – Cover the Terminal Block with the power supply cover.
Fig. 6.6: Power Cable and Fiberoptic Cable
Aiming Procedure
Point to point connections require the orientation face to face of both “transceiving” ends
of the link. Concerning wireless optical links, this should be done as accurately as
possible in order to position the beam symmetrically all around the remote receiver
.
Powering on the TereScope
Chapter
6
Fig. 6.1: Screws H and door axis
Fig. 6.4: Power cable & Terminal block
Fig. 6.2: Back Door Rotated ¼ of a turn
Door axis I
Fig. 6.
3
: View on Door axis
Fig. 6.7: Power Supply Cover
Power Supply
Cover
Fiberoptic Cable
Power Cable
Door axis I
Back Door
Hole “O”
and the
opposite
screw
Door axis I