MRV Communications TERESCOPE TS800/155 User Manual
Page 66
M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
56
allows for testing each transmitter separately. By rotating the devices
45 degrees, the next pair of transmitters is tested. Hence, testing all
8 transmitters in the link pair requires only 4 rotations.
In the 8” setup, the two devices are not centrally aligned; instead,
only one corner of each device faces the opposite device. This
allows for testing each transmitter separately. By rotating the devices
45 degrees, the next pair of transmitters is tested. Hence, testing all
6 transmitters in the link pair requires only 3 rotations. With opaque
masking tape, cover all transmitters that are not under test.
Table 1: Bench Test Information for TS Products
Product name Opt. Power M. “Sub-Saturation”
value
Potential for
Interference
TSxxxx 1100
Low
TSxxx/ETH 1200
Med
TSxxx/E1 1200
High
TSxxxx/ST 1200
Med
TS2000/XXX 1100
High
TS4000/XXX 1200
High
TSx00/XXX 1000
High
Figure E.1: Bench Test setup for 4”/Light TS models.
Figure E.2a: Bench Test setup for 10” TS model; transmitter aligned opposite receiver
marked with arrows.