MRV Communications TERESCOPE TS800/155 - Manual (Page 44)

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
34
The Installer Tool Kit (JITK-L)
The JITK-L tool kit includes the work tools required for opening and closing
nuts and screws of the TereScope for optimal installation. It is recommended
that these tools be used. MRV supplies this tool kit with each TereScope head.
In addition to the tool kit, screws are supplied for mounting the JMP-L on a
pedestal that is supplied by MRV as an option.
Fig. 5.9: JITK: Installer Tool Kit
Mounting
1- Detachment of the TS from the JMP-L
The TereScope Head, Aiming Head, and JMP-L are shipped connected to one
another. Before mounting, in order to make installation on the mounting
surface easier, the JMP-L must first be detached and connected to the fixation
surface. Next, the TereScope Head and Aiming Head can be mounted.
To detach the JMP-L, screws ‘B’ should be loosened and screws ‘F1’ and ‘G1’
only should be removed. Do not remove the ‘G2’ screws !
If the TereScope head is to be detached (e.g., for servicing, but we recommend
to send the entire unit TS + Aiming head to the manufactory), remove the
four ‘G2’ and ‘F2’ screws (Fig 5.11).
JITK: Installer Tool
Kit
Figure 5.10a: Mounting TS on JMP
G2 (x2)
G1
F1 (x2)
Figure 5.10b and 5.10c: Screws to be removed G1 and F1
B