Mocomtech CDM-QX - Manual (Page 129)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Front Panel Operation MN/CDMQX.IOM
5–63
When Demo Mode is turned On, the following messages display:
Please Wait… Resetting
Factory Defaults
PROCESSOR BOOTING…PLEASE WAIT!
[ ]
When the allotted demo period expires, the following message displays:
FAST Demo Mode: Off On
Demo Period Expired
From this time forward, once Demo Mode expires, the display reverts to the previous
(Demo Mode) submenu and On is rendered non-selectable.
UTILITY: FAST Æ Base Æ View
View Options: 02 (▲ ▼,ENT)
1:2 Redun - Installed
Use the ▲ ▼ arrow keys to display which FAST options are either Installed or Not
Installed for base unit operation. Press ENTER
when done.
UTILITY: FAST
Æ Slot#
FAST - Slot#1: Mod Turbo
(▲ ▼,ENT)
FAST - Slot#2: Demod Turbo
(▲ ▼,ENT)
Where # denotes the selected Slot#1, #2, #3 or #4: The Slot# menu screen indicates whether the
installed module is a Modulator, or Demodulator. If no module is present in the selected slot, the
following message displays:
THERE IS NO CARD
INSTALLED IN THIS SLOT!
The user will then be taken to the menu screen for the last valid slot in the configuration. From
there, select Mod (Demod) or Turbo using the
◄ ► arrow keys, then press
ENTER
.
UTILITY: FAST Æ Slot# Æ Mod, Demod
FAST: Config View
Board S/N: 223456789 (Mod#1)
FAST: Config View
Board S/N: 323456789 (Dem#2)
As with the menu screen for
UTILITY: FAST ÆBase , this menu screen identifies the serial
number for the board of the specific module installed in this slot position. Additionally, the
module type and its slot position are identified here. In the examples shown above, a Modulator
module resides in the Slot#1 position; a Demodulator module resides in Slot#2.
Select Config or View using the
◄ ► arrow keys, then press
ENTER
.