Mocomtech CDM-QX - Manual (Page 131)

6–1
Chapter 6. ETHERNET
MANAGEMENT
6.1 Introduction
The CDM-Qx/QxL base chassis is equipped for monitor and control purposes with an RJ-45 10/100
BaseT Ethernet management interface. This chapter provides a high-level overview of the
functionality provided by this interface, and references other chapters in this manual for further
details.
6.2 Ethernet Management Interface Protocols
The modem 10/100BaseT Ethernet Management Interface supports three (3) different management
protocols:
• SNMP with public and private MIB
• Telnet interface for remote product M&C
• Web Server interface for complete product management
IMPORTANT
In order to access the SNMP, Telnet, and Web Server features, the user must
make sure the unit is in Ethernet Remote Mode (Config
Æ
Remote
Æ
Ethernet).
It is not recommended to have write access enabled while using SNMP, Telnet,
or the Web at the same time.
6.3 SNMP Interface
The Simple Network Management Protocol (SNMP) is an application-layer protocol designed to
facilitate the exchange of management information between network devices. The CDM-Qx/QxL
SNMP agent supports both SNMPv1 and v2c.
IMPORTANT
For proper SNMP operation, the CDM-Qx/QxL MIB files must be used with the
associated version of the CDM-Qx/QxL modem M&C. Please refer to the pertinent
CDM-Qx/QxL FW Release Notes for information on the required FW/SW
compatibility.