Mocomtech CDM-QX - Manual (Page 202)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
EDMAC Channel MN/CDMQX.IOM
10–2
degradation. The net effect is that the user will see effectively identical BER performance
whether framing is used or not.
On the receive side:
When the demodulator locks to the incoming carrier, it must go through the additional step of
searching for, and locking to, the synchronization word. This uniquely identifies the start of
frame, and permits the extraction of the overhead bytes and flag bits at the correct position within
the frame. In addition, the start of frame permits the descrambler to correctly recover the data.
The user’s data is extracted and sent through additional processing in the normal manner. The
extracted overhead bytes are examined to determine if they contain valid M&C bytes.
10.2 M&C Connection
Data to be transmitted to the distant-end is sent to a local unit via the remote control port. A
message for the distant-end is indistinguishable from a ‘local’ message – it has the same structure
and content, only the address will identify it as being for a distant-end unit.
Before the M&C data can be successfully transmitted and received, pairs of units must be split
into EDMAC Masters and EDMAC Slaves. Masters are local to the M&C Computer, and Slaves
are distant-end.
Now, a unit which has been designated an EDMAC Master not only responds to its own unique
bus address, but it will also be configured to listen for the address which corresponds to its
EDMAC Slave. When a complete message packet has been received by the EDMAC Master, it
will begin to transmit this packet over the satellite channel, using the overhead bytes which
become available.
Note: The ‘normal’ protocol for the message packet is not used over the satellite path, as it is
subject to errors. For this reason, a much more robust protocol is used that incorporates extensive
error checking.
At the distant-end, the EDMAC Slave configured for the correct address receives these bytes.
When a complete packet has been received, it will take the action requested, then send the
appropriate response to the EDMAC Master, using the return overhead path on the satellite link.
The EDMAC Master assembles the complete packet and transmits the response back to the M&C
Computer.
Apart from the round-trip satellite delay, the M&C Computer does not see any difference
between local and distant-end units – it sends out a packet addressed to a particular unit, and gets
back a response. It can be seen that the EDMAC Master simply acts as forwarding service, in a
manner that is completely transparent.