Mocomtech CDM-QX - Manual (Page 217)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Appendix B MN/CDMQX.IOM
B–5
B.2.3 Acquire FAST Code
Contact a Comtech EF Data Customer Support representative to order features. You will be asked
to provide the pertinent serial numbers for the base unit motherboard, module motherboard, and
the modules’ TPC daughterboard.
The Comtech EF Data Customer Support representative will verify the order and provide an
invoice and instructions, including the pertinent 20-character FAST access/configuration code.
B.2.4 Enter FAST Codes
From the CDM-Qx/QxL front panel, prepare to enter the access codes obtained from Comtech EF
Data Customer Support:
1. Via the MAIN MENU: Using the ◄ ► arrow keys, select Utility, then press
ENTER
.
MAIN MENU: Config Monitor
Test Info Save/Load Utility
2. Via the Utility menu branch: Using the ◄ ► arrow keys, select FAST, then press
ENTER
.
UTILITY: RxBuffer Clock Ref
ID Display Firmware FAST
3. Via the UTILITY: FAST submenu: Using the ◄ ► arrow keys, select Base, Slot1, Slot2,
Slot3, or Slot3, then press ENTER
.
FAST – Select the module:
Base Slot1 Slot2 Slot3 Slot4
To activate newly-purchased features, proceed as instructed via the sections that follow.
B.2.4.1 Entering the Base Unit FAST CODE
Having selected MAIN MENU: Utility Æ FAST Æ Base:
FAST: Config View (HW 1.02)
Board S/N: 123456789 (Base)
Select Config using the ◄ ► arrow keys, then press
ENTER
.
FAST Configuration:
Edit Code Demo Mode
Select Edit Code using the ◄ ► arrow keys, then press
ENTER
.
Edit 20 digit FAST Code:
00000000000000000000 (ENT)
Enter the 20-digit FAST code that was obtained from Comtech EF Data carefully. Use the ◄ ►
arrow keys to first move the cursor to the numeral to be edited, then use the ▲ ▼ arrow keys to
edit that numeral (0-9). When all numbers are edited, press
ENTER
. The CDM-Qx/QxL will
respond with “Configured Successfully” if the FAST access code has been accepted;
otherwise, if the code is not valid, the following message displays:
FAST Code Rejected!
(ENT or CLR)