Mocomtech CDM-QX - Manual (Page 94)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Front Panel Operation MN/CDMQX.IOM
5–28
5.4.3.11 CONFIG: Rx
Æ CnC (CARRIER-IN-CARRIER
®
)
Carrier-in-Carrier (CnC):
Mode FrqOffs SrchDelay ReAcq
Select Mode, FrqOffs, SrchDelay, or ReAcq using the ◄ ► arrow keys, then press
ENTER
.
The user will then be taken to a further submenu. Note the following:
Mode
(Mode of Operation) This submenu permits the user to select the mode of operation
for the CnC.
FrqOffs
(Frequency Offset) This submenu permits the user to adjust the frequency offset for
the CnC.
SrchDelay
(Search Delay) This submenu permits the user to configure the search delay
parameters for the CnC.
ReAcq
(ReAcquisition Time) This permits the user to set the re-acquisition time in seconds
when the desired carrier is lost.
CONFIG: Rx Æ CnC Æ Mode
CnC Mode: Off On
(◄ ►,ENT)
To set the CnC Mode of Operation, select Off or On using the ◄ ► arrow keys, then press
ENTER
.
If On is selected, the front panel menu screen will display messages as follows:
LOADING CnC SAT SEARCH...
...PLEASE WAIT!
CnC SEARCH IS PROCESSING...
...PLEASE WAIT!
If the CnC Search is successful, the following message is displayed:
CnC SEARCH SUCCESSFUL!
Delay=239ms Offset=+001.0k
If the CnC Search is not successful, the following message is displayed:
CnC SEARCH IS UNRESOLVED!
PLEASE CHECK TX POWER LEVEL
CONFIG: Rx
Æ CnC Æ FrqOffs
CnC Frequency Offset:
+/-015 (▲ ▼ ENT)
To edit the CnC Frequency Offset, use the ST arrow keys to change the value, then press
ENTER when done.