Mocomtech CDM-QX - Manual (Page 78)

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier® Revision 7
Front Panel Operation MN/CDMQX.IOM
5–12
CONFIG: Remote Æ Ethernet Æ SNMP Æ Communities Æ Write
Write Community: (◄ ► ▲ ▼,ENT)
private
Edit either the SNMP Read or Write Community string by first selecting the
character to be edited using the
ef arrow keys, then change the character to be
edited by using the dc arrow keys. Only the first 20 characters on the bottom line
are available.
All printable ASCII characters are available with the exception of the backslash ( \
ASCII code 92) and the tilde (~ ASCII code 126). Once the string has been
composed, press
ENTER
. All trailing spaces are removed from the Read or Write
Community string upon entering.
CONFIG: Remote
Æ Ethernet Æ SNMP Æ Traps
Traps: Community Version
IP Addr#1 IP Addr#2 (◄ ►,ENT)
Select Community, Version, IP Addr#1, or IP Addr#2 using the ◄ ► arrow keys,
then press
ENTER
. Selecting Read displays the following submenu:
CONFIG: Remote
Æ Ethernet Æ SNMP Æ Traps Æ Community
Trap Community: (◄ ► ▲ ▼,ENT)
comtech
Edit the Trap Community string by first selecting the character to be edited using the
ef arrow keys, then change the character to be edited by using the dc arrow keys.
Only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash ( \
ASCII code 92) and the tilde (~ ASCII code 126). Once the string has been
composed, press
ENTER
. All trailing spaces are removed from the Community string
upon entering.
CONFIG: Remote Æ Ethernet Æ SNMP Æ Traps Æ Version
Trap Version: (◄ ►,ENT)
SNMPv1 SNMPv2
Select SNMPv1 or SNMPv2 using the ◄ ► arrow keys, then press
ENTER
.
CONFIG: Remote
Æ Ethernet Æ SNMP Æ Traps Æ IP Addr#X
Trap IP Addr#X: (◄ ► ▲ ▼,ENT)
000.000.000.000
Where ‘X’ designates the menu selection as IP Addr#1 -or- IP Addr#2: These two
IP Addresses are Trap Destination IP Addresses. Edit the IP Address by first
selecting the digit to be edited using the
ef arrow keys, then change the value of the
digit to be edited by using the dc arrow keys. Press ENTER when done.
Note: If both Trap IP Address are set to 000.000.000.000, it means Trap is disabled.