Japan Tiger 7100e+ User Manual
Page 128
Fast Ethernet
7100e+
128
Configuring IP addresses
If a PC running the Standard Setup Utility uses only TCP/IP
protocol, the Fast EtherNet may not be listed on the main screen
if its IP address has never been configured. Use the following
procedure to set the IP address.
Please make a note of the Ethernet Address before
proceeding with this setup. The Ethernet Address will
be displayed on the Fast EtherNet Self-diagnostic
Test.
1
Select [Set IP Address] from the [Setup] menu.
2
Enter the Fast EtherNet’s “Ethernet Address” and “IP
Address”, then click [OK]. The settings will be transmitted
to the Fast EtherNet.
3
To enable the IP Address, click [Yes].
If you select [No], the new setting will take effect
when you turn the printer off and then back on again.
7100e+.p65
25/08/99, 20:54 PM
128