Japan Tiger 7100e+ - Manual (Page 140)

Fast Ethernet 7100e+ 140
Using SNMP
The Fast EtherNet is equipped with an SNMP agent which runs
on UDP. The printer can be controlled using an SNMP Manager.
The Fast EtherNet supports SNMPv1, MIB-II and OKI Data
Private MIB. For OKI Data Private MIB, please use the file
appropriate to your printer, referring to “readme.txt” in the MIB
folder on the “Fast EtherNet CD- ROM”.
The default values for SNMP settings are as follows:
Items Value
Authentic Community Name Public
Trap Community Name Public
Trap IP Address 0.0.0.0
SysContact None
SysName None
SysLocation None
TTL Value (IP packet survival time) 255
Authentic Error Trap 2(disabled)
The default values for printer trap settings are as follows.
Items Value
Printer Trap Notice DISABLE
Trap Type LOCAL
Address (UDP) 0.0.0.0
Address (IPX) 00000000:000000000000
Fast EtherNet settings
The Fast EtherNet parameters and their values are described
bellow.
Some functions may not be used, depending on your printer
type.
The settings in Italics indicates Fast EtherNet default settings
Function
otocol is used for Ethernet Board.
Set TCP/IP Protocol for Ethernet Board.
Set IP Address for Ethernet Board. Enter
the value in a decimal system as
"***.***.***.***".
For RARP or DHCP/BOOTP, IP Address
setting is not required because it will be set
dynamically.
Set Subnet Mask for Ethernet Board. Enter
the value in a decimal system as
"***.***.***.***".
Set Gateway Address for Ethernet Board.
Enter the value in a decimal system as
"***.***.***.***".
Set whether RARP requirement (i.e.dynamic
IP Address acquisition) is conducted at
Printer start-up.
Set whether DHCP or BOOTP requirement
(i.e. dynamic IP Address acquisition) is
conducted at Printer start-up.
Set the root user password needed to
change Ethernet Board settings using
TELNET or other utilities. Enter the
password in 7 alphabets or numbers
Setup Value
ENABLE : To use thefunction.
DISABLE: Not to use the
function.
Default value
0.0.0.0.
Default value
0.0.0.0.
Default value
0.0.0.0.
ENABLE : To use the function.
DISABLE: Not to use the
function.
ENABLE : To use the function.
DISABLE: Not to use the
function.
Default value
None.
IItems
TCP/IP
TCP/IP protocol
IP address
Subnet mask
Gateway address
RARP protocol
DHCP/BOOTP
protocol
ROOT password
7100e+.p65 25/08/99, 20:55 PM 140