Japan Tiger 7100e+ - Manual (Page 56)

Fast Ethernet 7100e+ 56
Configuring the SunOS 4.x.x
Configuring to print from a SunOS 4.x.x BSD system UNIX.
If you type in a wrong IP address, subnet mask or
gateway, the network may go down or other severe
damage may occur. Please set the configuration only
after consulting your network manager.
In the following explanation, OKIPAGE 8c as the printer and
SunOS4.1.3 are used as an example. The absolute path of the
commands and the method of configuring may differ, depending
on the OS version. Please refer to your workstation’s manual.
Method of configuring
1. Log in as the root on the workstation.
In the case that there is no super user authorization,
leave the configuration to the network manager.
2. Register the IP address of the Fast EtherNet and the host
name in the /etc/hosts file.
Example: In the case that the IP address is “192.168.20.127”
and the host name is “OP8c”
192.168.20.127 OP8c
3. Use the ping command to confirm a connection with the
Fast EtherNet.
Example: In the case that the host name is “OP8c”
#ping OP8c
In the case that there is no reply, there is a problem
with the registration of the Procedure 2 IP address
and the host name, or with the condition of the
network. Please consult your network manager.
7100e+.p65 25/08/99, 20:50 PM 56