Japan Tiger 7100e+ - Manual (Page 87)

User Manual 87
English
Determine whether or not to enable the bindery mode. When
you print only with NetWare 4.1 NDS, uncheck this. Unchecking
this means the device cannot be used from NetWare 4.1 bindery
or NetWare 3.1.
Enter the tree name in which the file server exists (ODCSOFT in
this example). This must match “Tree Name” where the file server
to which you logged in exists.
Specify the context in which the file server has been generated
(SOFT22. ENG7 in this example). This must match “Context
Name” where you generated the print server, printer and print
queue earlier.
7 After all the settings are completed, click [Setup] on the
NetWare Setup screen.
8 If the settings are correct, click [Yes]. The settings will be
transmitted to the Fast EtherNet. At this point, however, the
Fast EtherNet is still operated using the previous settings.
9 Click [Yes] to reset the device.
If you select [No], the settings will become valid when
the printer is next power cycled. Depending on the
printer model used, you may need to power cycle it.
6 Click [NDS Settings] on the NetWare Setup screen, enter the
following items, then click [OK].
7100e+.p65 25/08/99, 20:51 PM 87