Japan Tiger 7100e+ User Manual
Page 94
Fast Ethernet
7100e+
94
7
If the settings are correct, click [Yes]. The settings are
transmitted to Fast EtherNet. At this point, however, Fast
EtherNet is still operating according to the previous
settings.
8
Click [Yes] to reset the Fast EtherNet.
•
If you select [No], the new settings will take effect after
the printer is power cycled.
•
You may have to power cycle (switch off, then on again)
the printer depending on the model.
9
When [Current Status] changes to [Waiting for Print Job],
the printer is ready.
If the status does not change to [Waiting for Print Job], set
the file server and Fast EtherNet again from the beginning.
<Print Server Status>
Printer: P1.SOFT22.ENG7
Type: Manual Load (Remote), LPT1
Current Status: Waiting for Print Job
Check the status of printer connection
7100e+.p65
25/08/99, 20:51 PM
94