SATO CL 408e - Manual (Page 127)

Page 6-27
Section 6. Replacement Procedures
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
6.13 Replacing the Head Open Switch
The Head Open Switch is easily replaced for service.
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the access door and remove (2) screws holding the side cover to the
inside frame. Figs. 6-1
3. Remove (2) screws holding the side cover to the outside frame. Remove the
cover to expose the electronics.
4. Remove (2) screw which attaches the Head Open Switch to the frame.
Figs. 6-34
5. Detach the connector from the display panel PCB.
6. Remove the swich unit from the printer.
7. Replace the switch.
8. Reconnect the power cable.
REMOVE (2) SCREWS TO
DETACH SWITCH FROM
FRAME
LOCATION OF HEAD
OPEN SWITCH
Figs. 6-34