SATO CL 408e - Manual (Page 42)

Page 2-22
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
card-> memory copy
copying
This selection allows you to copy printer firmware from the PCMCIA Memory card to the
printer.
Card->Memory Copy
Program Y/N
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
IF Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the mode display.
2. Confirm your selection by stepping the underline cursor to the Yes
selection. If you select No, the display will return to the previous
selection.
3. Press the FEED key to accept the selection. If Yes was selected, the
copy process will start.
4. Once the copy process is completed, press the FEED key to advance
the display.
5. If an error is encountered in the copy process, one of the following
messages will be displayed on the second line.
R/W Error Indicates a Read/Write error occurred
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available
copy start
yes no
card-> memory copy
completed
CARD COPY/FORMAT
XXXXXXX ERROR
card ->memoryCopy
program y/n
LCD Panel — Card Mode