SATO CL 408e - Manual (Page 58)

Page 2-38
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
(Countinued)
STEP PROCEDURE
3. Transmit the download data command stream to the printer.
4. After the data has been received, the printer will beep and print a status
label. If it does not beep and print a status label, the printer did not
accept the data.
5. If the printer did not beep and print a status label, turn the printer off and
check you data stream for errors snd start the download process over.
6. If the custom codes are correct, press the FEED key to accept them and
terminate the download process. If they are incorrect, turn the printer off
without pressing the FEED key and begin the process again.
LCD Panel — Download User Defined Protocol Codes
User Download
Press the Line Key
Hex Dump Mode
In addition to the User Test Print Labels, the printer can print the contents of the receive buffer
in a hexadecimal format to allow the data stream to be examined for errors and troubleshooting.
To enter the Hex Dump mode, place DSW2-4 in the ON position and power on the
printer.
Online
STEP PROCEDURE
1. The printer is now ready to receive data.
2. Send the data stream to the printer.
3. The receive data will be printed in a hexadecimal format.
4. To return the printer to normal position, place DSW2-4 in the OFF
position and power the printer OFF and then back ON.
online
qty:000000
initializing
rom v00.00.00.00
Refer to the Operator and Technical Reference Manual for the data stream
command structure required.