SATO CL 408e - Manual (Page 157)

Page 9-3
Section 9. Optional Accessories
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
REMOVE FRONT DOOR
FROM CL-408/412e
PRINTER
Label Cutter Kit Installation - Guillotine Type
STEP PROCEDURE
7. Remove the connector cover (located under the DSW2 and DSW3 switches)
and install the interface cable to the connector. The connector is keyed and
should easily slide onto the pins. If it does not, verify that you are installing
the cable correctly and that there are no bent pins on the connectors. Fig. 9-8
8. Set switch location of DSW3-1 to the ON position.
9. Load the label stock and gently close the printer front door whnile feeding the
labels through the cutter assembly and the front door. Verify that the labels
feed through the cutter assembly without jamming. Take care that while
closing the front door the interface cable is properly routed to avoid crimping.
Close the right side cover.
10. Power up the printer and verify cutter operation. Run several labels and adjust
the pitch offset so that the cutter activates at the desired location. If necessary,
turn the adjusting wheel on the cutter to produce correctly oriented labels that
are parallel with top label opening. Fig. 9-1
Fig. 9-2