SATO CL 408e - Manual (Page 86)

Page 4-12
Section 4. Electric Checks and Adjustments
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
4.8 Offset Label Stop Position Adjustment
The Label Stop Position is adjusted with the Offset potentiometer on the Front Panel.
STEP PROCEDURE
1.Open the Front Door for access to Offset-VR.
2.Turn Offset-VR to the center position.
3.Press the FEED key while simultaneously turning ON the power switch.
4.When the printer beeps, release the key.
The following screens will appear.
5.Press the FEED key to display the next screen.
6.Use the LINE Key to step to the second digit of the counter to the desired
setting. The display will increment one step each time the LINE key is
pressed. After the reading will advances to a setting of 09, it will
automatically wrap and start at 10 CM again.
7.Press the FEED key for a test print. Press the FEED key again to stop
printing.
8.Adjust stop the position using the Offset-VR and feed another label. When the
adjustment is correct, turn the printer off. If the print position can't be
adjusted replace the Display Panel PCB. Refer to Section 6.
initializing
rom v00.00.00.00
test print mode
configuration
test print size
10cm
press feed key
to stop printing
OFFSET-VR
Note: The stop position only is
changed with the Offset-VR.
The print position is changed with
the Pitch-VR.
The OFFSET-VR adjustment range
is +/- 3.75mm.
Used for fine adjustment of label stop position for Tear Off, Cutter and Dispense Modes.