SATO CL 408e - Manual (Page 24)

Page 2-4
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
Protocol Code Selection (DSW2-7):
Selects the command code set used.
DSW2
ON
OFF
1 2 3 4 5 6 7 8
DSW2
ON
OFF
1 2 3 4 5 6 7 8
DSW2-7 SETTING
Off Standard
On Non-Std.
Dip Switch Settings
DSW2-6 SETTING
Off Disabled
On Enabled
Firmware Download (DSW2-6):
Places the printer in the Firmware Download mode
for downloading new firmware into flash ROM.
DSW2
ON
OFF
1 2 3 4 5 6 7 8
M8400 Emulation Mode (DSW2-8):
For emulating earlier series software
commands. Should be used only if problems are encountered when using existing
software. This switch will also affect the setttings selected by DSW1-7 and DSW1-8.
DSW3
ON
OFF
1 2 3 4 5 6 7 8
DSW3-1 DSW3-2 SETTING
Off Off Batch/Continuous
Off On Tear Off
On Off Cutter
On On Dispenser
Mode Selection (DSW3-1 and DSW3-2):
 Selects the operating mode of the printer.
Batch/Continuous disables the label taken (dispense option) sensor.
DSW2-8 SETTING
Off Disabled
On Enabled