Sharp AR-650 - Manual (Page 160)

156
8 Set the staple cartridge.
. Insert the cartridge until the claw catches it.
Note: Repeat steps 1 to 11 if the test stapling
is not performed and "Set staple cartridge"
is displayed.
9 Reinstall the stapler unit in its previous
position.
. Turn the blue lever 90 degrees to the right
to latch the stapler unit.
Confirm that the finisher is attached to the
copier, and that the paper size is set to any
size other than Statement-R.
. A staple test cannot be performed when only
the Statement-R paper is available. So make
sure to set another size.
10
11 Close the front cover of the finisher.Test
stapling is automatically carried out at some
of 12 places of a blank sheet of paper as
in the right-hand figure.
No.12
No.3
No.2
No.1
Direction of
paper path
Staple
cartridge
8. REPLACING STAPLES (OPTIONAL) (Cont.)