Sharp AR-650 - Manual (Page 21)

17
HOW TO MAKE COPIES
If you set the desired copying modes and press the START key during warm-up, the copier
automatically starts copying when it becomes READY. Follow the procedure below to set up
the Auto Job Start mode.
Place the original(s) on the original feed
tray or on the glass.
When Using the Automatic Document Feeder
. After aligning the edges of the originals, set
them face up on the original feed tray and
align the slides to the edges of the originals.
. The number of the originals you can set up
at a time is shown below.
Letter, Letter-R, Statement-R : 60
Ledger : 30
Legal : 35
1
2
Auto Job Start Mode
When Placing the Original on the Glass
. After lifting the automatic document feeder,
place the original on the glass face down with
the bottom toward you and the left side
centered against the original scale.
Note: Remove any paper clips or staples from
originals before placing them on the
original feed tray.
Set the desired copy modes.
. The automatic paper selection (APS) mode,
auto-exposure mode and copying of one
original are the default settings.
Slides
Original
Automatic
document
feeder
Original
scale