Sharp AR-650 - Manual (Page 28)

24
When the power switch is turned ON, the Automatic Paper Selection (APS) mode is set as
the default mode.
In this mode, if you place an original on the original feed tray or on the glass, the copier
automatically detects the size of the original, and selects paper of the same size as the original.
This mode is available only for actual-size (100%) copying.
Check that the Automatic Paper Selection
mode is selected.
1
2
. After aligning the edges of the originals, set
them face up on the original feed tray and
align the slides to the edges of the originals.
. The number of originals you can load at a
time is shown below.
Letter, Letter-R, Statement-R : 60
Ledger : 30
Legal
: 35
. When the START key is pressed, the sensor
detects the size of the original, and selects
the paper size matched to the original.
When Using the Automatic Document Feeder
3. COPYING IN THE AUTOMATIC PAPER SELECTION MODE
Place the original(s) on the original feed
tray or on the glass.
Note: Remove any paper clips or staples from
originals before placing them on the
original feed tray.
Slides