Sharp AR-650 - Manual (Page 57)

53
HOW TO MAKE COPIES
JOB PRESET is a feature that allows another job to be set while a current job is being done.
You can preset the next copy modes during a copy run.
You cannot preset the next copy modes during the scanning of the originals.
15. PRESETTING OF COPY MODES
1 Press the JOB PRESET key during a copy
run.
2 Set the next copy modes.
3 Place the originals on the original feed tray
and press the START key.
4 The preset job will start when the current
copying is finished.
. To cancel the preset copy modes, press the
JOB CANCEL key.
Note: If the STOP key is pressed or the copy
run is interrupted due to running out of
paper, etc. during job presetting, the set
modes are cleared. Set the desired copy
modes again after the copy operation
restarts.