Transporting your interactive whiteboard system, Contacting smart technical support – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 105
89 |
CHAPTER 6 – MAINTAINING YOUR INTERACTIVE WHITEBOARD SYSTEM
8. Confirm that the projector is operating and that the lamp module is correctly
installed by pressing the Power
button once on the remote control or ECP,
and then waiting for the projector to turn on completely.
The ECP’s power light turns solid green when the system starts.
9. Wait five minutes for the projector to warm up.
NOTE
You may need to adjust the projected image after performing the previous
procedures. For more information, see the included
and the tips on
Transporting Your Interactive Whiteboard
System
Save your original SMART Board 600i4 or D600i4 interactive whiteboard system
packaging so that it’s available if you need to transport your interactive whiteboard
system. When required, repack it with as much of the original packaging as possible.
This packaging was designed with optimal shock and vibration protection. If your
original packaging is no longer available, purchase the same packaging directly from
If you prefer to use your own packaging materials, make sure you adequately protect
your unit. Ship your interactive whiteboard in an upright position to deter shippers from
placing heavy objects on it.
Contacting SMART Technical Support
See Appendix B:Customer Support on page 101 for technical support contact
information.
Before contacting SMART Technical Support, make note of the projector’s serial
number, and then write it down on the inside cover of this manual (if you printed it).