Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 7)

v | IMPORTANT INFORMATION
• When returning the projector to the boom, replace all of the screws that you
removed when you removed the projector. Failure to do so can result in the
projector falling from the boom, causing personal injury or product damage.
• To reduce the risk associated with a leaking battery in your projector’s remote
control:
– Use only the specified coin-cell type battery.
– Orient the battery’s plus (+) and minus (-) terminal according to the
markings on the remote control.
– Remove the battery when the remote control is unused for an extended
period.
– Do not heat, disassemble, short or recharge the battery, or expose it to
fire or high temperatures.
– Avoid eye and skin contact if the battery has a leak.
– Dispose of the exhausted battery and product components in accordance
with applicable regulations.
CAUTIONS
•
Do not operate this unit immediately after moving it from a cold location
to a warm location. When the unit is exposed to such a change in
temperature, moisture can condense on the lens and crucial internal parts.
Allow the system to reach room temperature before operation to prevent
possible damage to the unit.
• Do not place the unit in hot locations, such as near heating equipment.
Doing so could cause a malfunction and shorten the life of the projector.
• Do not set up or use your interactive whiteboard system in an area
with excessive levels of dust, dirt, humidity or smoke.
• Do not place your interactive whiteboard system in direct sunlight or near any
appliance that generates a strong magnetic field.
• Do not rest your interactive whiteboard on its side or on the top of its frame.
• If you need to lean your interactive whiteboard against a wall before you
mount it, make sure that it remains in an upright position, resting on its pen
tray brackets, which are designed to sustain your interactive whiteboard’s
weight.
• For operating safety and to prevent damage to your interactive whiteboard,
connect the included USB cable only to a computer that has a USB compliant
interface and that bears the USB logo. In addition, the USB source computer
must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA
and/or UL Mark(s) for CSA/UL 60950.