Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 113)

97 | APPENDIX A – DISABLING USB COMMUNICATIONS
To remove the USB
jumper switch
1. Locate the USB jumper behind the jumper cover port.
2. Using needle-nose pliers, pull the jumper from the two connection posts, and then
place it on a single post.
IMPORTANT
Do not discard the jumper. Discarding the jumper makes the USB deactivation
difficult to reverse.
3. Insert the USB jumper cover into the USB A port on the front of the ECP.
4. Connect all cables to the ECP. See page 32 for more information.
5. Secure the ECP to your interactive whiteboard with the two screws you removed
previously.
6. Connect the projector’s power cable to the power outlet.