Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 8)

vi | IMPORTANT INFORMATION
• Do not block the projector’s ventilation slots and openings.
• Avoid turning off the projector during the lamp ignition phase because this can
lead to premature lamp failure. Keep the projector lamp on for a minimum
of 15 minutes before turning it off to preserve the lamp life.
• In a high altitude location over 6000' (1829 m), where the air is thin and
cooling efficiency is reduced, use the projector with the fan mode set to High.
• Cycling power to the projector repeatedly can lock or damage your interactive
whiteboard system. After you turn off the system, wait at least 15 minutes
for cooling before starting the system again.
• To prevent tampering or unintentional changes, only system administrators
should access the service menu. Do not share the service menu access code
with casual users of your interactive whiteboard system.
• Do not adjust any settings in the service menu other than those listed in the
following procedures. Changing other settings might damage or affect the
operation of your projector and invalidates your warranty.
• If dust or small items prevent pen tray buttons from being pressed or cause
constant button contact, remove the obstructions carefully.
• Before you clean the SMART UF65 or SMART UF65w projector, press the
Power button twice on the extended control panel (ECP) or remote control
to put the projector into Idle mode, and then allow the lamp to cool for 30
minutes.
• Do not spray cleaners, solvents or compressed air near any part of the
projector, since they can damage or stain the unit. Spraying the system could
spread a chemical mist on some of the projector’s components and lamp,
resulting in damage and poor image quality.
• Do not allow liquids or commercial solvents of any kind to flow into the
projector.
• When transporting your interactive whiteboard system, repack it with as much
of the original packaging as possible. This packaging was designed with
optimal shock and vibration protection.
• If your interactive whiteboard system requires replacement parts, make sure
that the service technician uses replacement parts specified by SMART
Technologies, or parts with the same characteristics as the original.