Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 60)

44 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
Powerstate Controls
These commands turn on or turn off the projector and request the projector’s current
powerstate. The projector’s powerstate determines whether or not certain commands
are available at that time. These settings are always available, even when the
projector is off.
Powerstate Command Description
Powerstate Response Field Description
Command Response
on powerstate=[field]
off powerstate=[field]
off now powerstate=[field]
get powerstate powerstate=[field]
Command Description
on Turns on the projector.
off Starts the shutdown process. A dialog box appears with the
message, “Press Power Button to Turn off Projector.”
You must send a second Off command within 10 seconds
to completely turn off the projector.
off now Shuts down the projector immediately. You can’t delay or
cancel this command.
get powerstate Indicates the projector’s current powerstate.
Field Description
Powering The projector is turning on.
On The projector is on.
Cooling The projector is cooling.
Confirm off Confirm off is a non-selectable powerstate that is returned
during stage one of the two-button off sequence.
Idle The projector is off but still receiving power (standby).