Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 112)

96 | APPENDIX A – DISABLING USB COMMUNICATIONS
To remove and cut the
case on the ECP
1. Turn off the projector, and then wait 15 minutes for it to cool down.
2. Disconnect the projector’s power cable from the power outlet.
3. While holding the ECP to prevent it from falling, use a Phillips screwdriver to
remove the two screws from the bottom of the ECP. Place the screws in a safe
place.
4. Remove all cables connected to the ECP.
5. Locate the jumper cover between the “PC” and “SE240” labels on the side of the
ECP that faces the wall.
6. Using a pair of wire cutters, cut through the two tabs on the jumper cover and
remove it from the ECP. Keep the jumper cover in a safe place.