Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual

Page 6

Advertising
background image

iv

|

IMPORTANT INFORMATION

This projector detects its remaining lamp life. Replace the lamp when a lamp
life warning message appears. If you continue to use the projector after the
replacement message appears, the lamp can shatter or burst, scattering
glass throughout the projector.

If the lamp has shattered or burst:

Call your

authorized SMART reseller

for instructions. Do not attempt

to replace the lamp.

Do not touch the glass fragments because they can cause injury.

Leave and then ventilate the area where the lamp shattered or burst.

Wash your hands thoroughly if you have come in contact with
lamp debris.

Thoroughly clean the area around the projector, and then discard any
edible items placed in that area because they could be contaminated.

You must remove the projector from its boom before servicing the lamp.

Two people are required to remove and replace the projector.

Replacing the lamp in a boom-mounted projector might result in a fall
or injury.

Uncovering the lamp while the projector is mounted on the boom might
lead to product damage or personal injury from falling pieces of glass
if the lamp is broken.

When replacing the projector lamp:

Use only replacement lamps approved by SMART Technologies. Contact
your

authorized SMART reseller

for replacement parts.

Never replace the lamp assembly with a previously-used lamp assembly.

Turn the projector off and wait 30 minutes for the lamp to cool completely
before removing the projector from the boom.

Wear protective eyewear while changing the lamp. Failure to do so can
cause injury or loss of eyesight if the lamp shatters or bursts.

To prevent premature lamp failure or exposure to mercury, always handle
the fragile lamp assembly with care. Use gloves when touching the lamp.
Do not touch the lamp with your fingers.

Do not remove any screws other than those specified in the lamp
replacement instructions.

Recycle or dispose of the lamp module as hazardous waste,
in accordance with local regulations.

Advertising
This manual is related to the following products: