Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 108)

92 | CHAPTER 7 – REPLACING THE SMART UF65 OR SMART UF65W PROJECTOR
LAMP
You require a Phillips No. 2 screwdriver to perform the following procedure.
To remove and replace
the projector lamp module
1. Remove the outer lamp cover with your finger and set it aside.
2. Using a Phillips No. 2 screwdriver, loosen the two screws on the inner lamp
module. The screws remain captive inside the lamp module.
3. Pull up on the lamp module’s handle, and then remove the lamp.