Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 9)

vii | IMPORTANT INFORMATION
IMPORTANT
•
Use the installation instructions included in the SMART UF65 or SMART
UF65w projector boom box to install your system. Do not use the instructions
in your SMART Board interactive whiteboard box.
• Make sure that an electrical socket is near to your SMART product and
remains easily accessible during use.
• Using the SMART UF65 or SMART UF65w projector system near a TV or
radio could cause interference to the images or sound. If this happens, move
the TV or radio away from the projector.
• If you have peripheral devices that do not use a 4-pin mini-DIN connector or
an RCA composite video jack, or if your device has an audio connection that
does not use RCA jacks, you may need to purchase third-party adapters.
• There are no projector menu options on the ECP. Keep your remote control in
a safe place because the ECP is not a substitute for the remote control.
• Do not disconnect existing USB plugs on the ECP to connect other
peripherals, because you could disconnect controls for your interactive
whiteboard or host computer.
• Turn off your interactive whiteboard system before cleaning it.
• Follow these guidelines to clean the projector:
– Wipe the exterior of the projector using a lint-free cloth.
– If necessary, use a soft cloth moistened with a mild detergent to clean the
projector housing.
– Do not use abrasive cleaners, waxes or solvents.
– Avoid touching the lens. If it is necessary to clean the lens:
– Use liquids or commercial solvents (such as glass cleaners) to clean
the lens, but do not spray them directly on the system.
– Use protective gloves and dip a lint-free cloth (such as Purestat®
PW2004) in an anti-static solvent (such as Hyperclean® EE-6310).
– Gently wipe the lens from the center to the edge.
• Disconnect the product from its power source when it’s not used for a
long period.