Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 57)

41 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
NOTES
•
Asynchronous mode is disabled by default in the projector.
• All commands should be in ASCII format. Terminate all commands with a
carriage return.
• All responses from the projector are terminated with a command prompt.
Wait until you receive the command prompt, indicating that the system is
ready for another command, before proceeding.
• The room control feature of the projector is always on.
To configure
your computer’s
serial interface
1. Turn on your computer, and then start your serial communications program or
terminal emulation program.
2. Connect your computer to the serial connection cable you previously attached to
the projector.
3. Configure your serial interface settings using the values in the table in the
previous section, and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a
command prompt on the following line.
NOTE
If no message or an error message appears, your serial interface
configuration isn’t correct. Repeat step 3.
4. Type commands to configure your settings.
NOTES
–
To see a list of available commands, type ? and then press ENTER.
– When you’re using a terminal emulation program, turn on your program’s
local echo setting if you want to see characters as you type them.