Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 110)

94 | CHAPTER 7 – REPLACING THE SMART UF65 OR SMART UF65W PROJECTOR
LAMP
Resetting the Lamp Timer
After you replace the lamp, you need to access the projector service menu and reset
the lamp hour counter. To prevent accidental errors, only a system administrator
should perform this procedure.
NOTE
Always reset the Lamp Hours after you exchange a lamp. Lamp service reminders
are based on the current hours of use.
To reset the lamp timer 1. Using the remote control, press the following buttons quickly to access the service
menu: Down, Up, Up, Left, Up.
CAUTION
Do not adjust any settings in the service menu other than those listed in this
procedure. Changing other settings might damage or affect the operation of
your projector and will invalidate your warranty.
2. Scroll down to the Lamp Hour Reset field, and then press OK.
Both Lamp Hour values (Standard and Economy) are reset to zero.
CAUTION
Do not use the Lamp Hour Reset feature unless you have just replaced the
lamp. Resetting the lamp hour counter on an old lamp might damage your
projector due to lamp failure.
NOTE
You’re unable to reset the Display Hour value because it’s the running total of
hours the projector has been in use.
3. Press the Menu button on the remote control.
The SMART UF65 Settings menu appears.
4. Select to confirm that Lamp Hours has been reset to zero.
Your system is ready for use.