Tips for adjusting the projected image – Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 User Manual
Page 32
16 |
CHAPTER 2 – ADDITIONAL DETAILS FOR INSTALLING YOUR INTERACTIVE
WHITEBOARD SYSTEM
Tips for Adjusting the Projected Image
Refer to these notes when adjusting the projected image as described in the included
•
Project a computer image (set to the proper resolution) while adjusting the image.
If you don’t have a computer, use the projector’s default background so that you
can see the full projected image clearly.
•
Don’t use the projector’s on-screen menu options to make image adjustments.
Instead, use the mechanical adjustments described in the installation document.
•
Don’t loosen the wingnut on the top of the ball joint too much or the projector won’t
hold the adjustments.
•
As you tilt the projector up or lower its mounting boom to raise the image, the
entire projected image may increase slightly in size during this process, and more
at the bottom of the projected image than at the top.
•
Don’t pay attention to the position of the left and right edges relative to your
interactive whiteboard when you move the projector left or right until both the top
and bottom edges of the image are horizontal.
•
When you move the projector forward or backward on the boom to make the
image larger or smaller, you may need to tilt or turn the projector slightly to keep
the image square.
•
To fine-tune the image, you may need to repeat all steps described in the
installation document in smaller increments.