Smart Technologies Smart Board Interactive Whiteboard Systems 600i4 - Manual (Page 59)

43 | CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
See the following example for adjusting projector brightness:
>get brightness
brightness=55
>set brightness=65
brightness=65
>set brightness+5
brightness=70
>set brightness-15
brightness=55
Video Source Specification Values
You can use the source input field described on page 45 in a command to set an
absolute value or adjustment value to a source other than the active source. You can
do this while the selected source is inactive, but the source device must be connected,
or you’ll receive an invalid command response. The operational parameters are
VGA1, VGA2, Composite or S-Video.
The following examples set the brightness of VGA1, regardless of whether it’s the
current source or not.
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58