Samson 5476 - Manual (Page 10)

1.4 Displaying data
Measured values, set points, times-of-use, public holidays and vacation periods as well as tem-
peratures of the connected sensors and their set points can be retrieved and displayed in the op-
erating level.
Proceed as follows:
Select value.
The various datapoints appear one after the other on the display depending on the con-
figuration (–> Fig. 11 on page 112).
Outdoor temperature
Temperature at flow sensor VF in heating circuit 1, 2
Temperature at return flow sensor RüF1
Room temperature
Temperature at flow sensor VF1 while DHW is active
Temperature at flow sensor in DHW circuit VF2 – VF3
Temperature at DHW sensor VF2
Temperature at storage tank sensors SF1–SF2
Temperature at return flow sensor in DHW circuit RüF2
Temperature at solar collector sensor CF
Time schedule for heating
, Time schedule for DHW circuit
Public holidays
Vacation periods
Compare the set point or limit with the actual measured temperature.
By pressing the enter key when the time appears on the display, a status alarm of the
system bus interface appears when the Modbus operation is active.
If the system bus interface is not used accordingly,
PAUSE appears on the display.
10
EB 5476 EN
Operation