Samson 5476 - Manual (Page 17)

2 Start-up
2.1 Setting the system code number
10 different hydraulic schematics are available. Each system configuration is represented by a
system code number (Anl). The different schematics are dealt with in section 4. Available con-
troller functions are described in sections 5, 6 and 7.
Changing the system code number resets previously adjusted function blocks to their default set-
tings (WE). Function block parameters and settings in the parameter level remain unchanged.
The system code number is set in the configuration level.
Proceed as follows: Switch to the parameter level.
Display shows: Time,
blinks
Switch to the configuration level.
Display shows: Current system code number,
blink
Activate editing mode for system code number.
“Anl“ blinks on the display.
Set system code number.
Confirm system code number.
Exit the configuration level.
Return to the operating level.
2.2 Activating and deactivating functions
A function is activated or deactivated in the associated function block. The numbers 0 to 24 in
the top row of the display represent the respective function block numbers. When a configura-
tion level is opened, the activated function blocks are indicated by a black square on the
right-hand side below the function block number. The first level of the display shows the function
blocks 0 to 23 and the second level shows the status of function blocks 24 to 47.
The function blocks are described in section 12.1.
EB 5476 EN
17
Start-up
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24