Konica Minolta 7013 - Manual (Page 103)

Advanced features
Important: While in PIN Mode 1, any autodialer numbers you use must include
the PIN . This also applies to autodialer numbers used with batch
transmission (see page 3.11) or programmable one-touch keys (see
pages 3.34–3.48).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission,
you must store the PIN access code for the remote unit within the appropri-
ate batch box.
If you chose “Mode 2” — as you autodial, load the code
In this mode, you don’t have to add the PIN to the autodialer setting. Instead, you
enter the PIN manually each time you autodial:
1 Dial the number as you normally would, using the autodialer. Here, we’ve
pushed one-touch key
A . The machine now asks for the PIN :
2 Use the numeric keypad to enter the PIN .
3 Press START . Your machine dials the number.
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see page 3.11), you must store the PIN access code for the remote unit
within the appropriate batch box.
Dialing from the numeric keypad while using the PIN mask
If you’ve specified Mode 1 — use “star” power
1 Enter the phone number, then press the * (“star”) key and enter the PIN .
The PIN always goes last. For example, to dial 19725550911 with a PIN of
“123456”, enter 19725550911*123456:
2 Press START . The PIN disappears from the display, and your machine dials the
desired phone number.
If you’ve specified Mode 2 — the machine guides you
1 Enter the phone number as usual.
2 Press START . The LCD shows:
3 Use the numeric keypad to enter the PIN .
4 Press START . Your machine dials the number.
Performing batch transmission while using the PIN mask
Note: The following instructions presume you are familiar with how to set and use
both your machine’s autodialer and its batch transmission feature. If you
need to review, see pages 3.1–3.8 for more on the autodialer and/or page 3.11
for more on batch transmission.
If you’ve specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include
the PIN . (To review how to include this information in an autodialer
number, review the Mode 1 instructions under “Autodialing while
using the
PIN mask,” page 3.51.)
Before sending a batch transmission the first time, you must store the PIN within its
batch box. Here’s how:
1 Follow the steps for creating or modifying a batch box (pages 3.11–3.12).
The
LCD asks for the fax number (here, we’re working with batch box 1):
2 Enter an autodialer number, or use the numeric keypad to enter the fax num-
ber, to which the batch transmission should go.
Important: If you’re entering a number from the numeric keypad, enter the
fax number, followed by the * (“star”) key and then the PIN .
1:Fax Number
_
Enter PIN Number
123456_
Enter PIN Number
_
Press Start
19725550911_
Press Start
19725550911*123456_
Enter PIN Number
1057_
Enter PIN Number
_
3.52