Konica Minolta 7013 - Manual (Page 114)

Changing the default settings
Changing the dialing pause length
Default setting: 2 seconds
The pause is set by the factory to last two seconds, but you can set it to last as long
as ten seconds if necessary. To change the pause length:
1 Press Program key, B , 2, 0, 5, ENTER .
2 Use the numeric keypad to enter the length you want for the dialing pause.
Here, we’ve chosen nine seconds.
Note: The length setting requires two digits. Always enter a leading zero for
lengths less than 10 seconds.
3 Press ENTER to save the setting.
Changing redial settings
Default setting: Number of redial: 2 times, Redial interval: 3 minutes
It’s up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval).
To program the redial settings:
1 Press Program key, B , 2, 0, 4, ENTER .
2 Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 5 redials. In this example, we’ve entered 3.
3 Press ENTER to save the setting.
4 The LCD now shows:
5 Use the numeric keypad to enter the length you want between redial
attempts. Choose from 3 to 5 minutes. In this example, we’ve chosen 4.
6 Press ENTER to save the setting.
Redial Interval
Interval (3-5):4
Redial Interval
Interval (3-5):3
# Of Redials
# (2-5):3
# Of Redials
# (2-5):2
Dialing Pause
Time (02-10):09
Dialing Pause
Time (02-10):02
4.5
Settings for dialing