Konica Minolta 7013 - Manual (Page 127)

Just in case …
What you see on the LCD What it means/What to do
Document Full You tried to enter an document into an F-Code
box, but the machine has reached its capacity
(30 documents). Delete documents stored in
F-Code boxes until the machine will let you pro-
ceed.
Document Jam An original document jam while you are using
ContStor Enter/Cancl the ADF for either faxing or copying. See page 5.1
for instructions on clearing the jam.
Document Stored You tried to erase a batch box which contains at
least one document. Erase the document(s), then
try again.
Enter No. (0-32) You tried to enter a call group number greater
than 32. Your machine can maintain 32 call
groups, numbered 1-32 (call group 0 covers all
the groups). Determine the correct call group
identifier number and enter it, instead.
Enter Reduce/Enlarge You tried to copy your document on the paper
other than A4, A5
or F4 sized paper using the
bypass tray, or the calculated reduction or
enlargement ratio is out of the acceptable range
(50 – 200 %) when the copy reduction or
enlargement ratio is set to “Auto”.
Enter the reduction or enlargement ratio manu-
ally although a part of the image might be
lacking, or change the paper for copying.
Enter Scan Size When you using the platen glass, you must
manually enter the scan size of your document.
Press
DOCUMENT SIZE to choose the size.
Feeder In Use The command you’re trying to enter requires the
use of the
ADF , which is already in use. Wait for
the machine to stop using the ADF , then try
again.
What you see on the LCD What it means/What to do
In Relay Box You tried to store a document for polling in an
F-Code box which is set to be a relay box.
Select an F-Code box which is set to be a bulletin
box, then try again.
In Secure Box You tried to store a document for polling in an
F-Code box which is set to be a security box.
Select an F-Code box which is set to be a bulletin
box, then try again.
In Use in P OneTouch You tried to erase the F-Code box or Batch box,
which is programmed in the programmable one-
touch key.
Erase the programmable one-touch key that con-
tains the F-Code box or Batch box you want to
erase, then try again.
Invalid I.D. Code The F-Code box I . D . code you entered isn’t valid.
Try re-entering your F-Code box I . D . code.
Invalid Number You pressed a key which has no function during
the current operation.
Invalid Paper Size If the optional printer controller is attached to
your machine, it can use the special sized paper
with the bypass tray. However, it should be used
only for the PC printing, it cannot be used for
copying. So, if you tried to copy onto the special
sized paper with bypass tray, this message will
appear.
Invalid Passcode The protection passcode you entered isn’t valid.
Repeat the operation, entering the correct protec-
tion passcode.
Line Busy You tried to erase a document which someone is
polling from your machine. Wait for the fax to
complete the polling operation, then try again.
5.6