Konica Minolta 7013 - Manual (Page 112)

Print settings
You can set three parameters for printing received fax messages:
• Print reduction rate
• Reduction margin
• Paper save function
You set all three in the same procedure, discussed on next page. Following is a
explanation for each:
Print reduction rate
Print reduction lets you set the machine to reduce large incoming documents to a
size that fits the paper in your machine. (This setting doesn’t affect copies you may
make with your machine.)
Below are the options for the print reduction rate for fax reception:
Setting What it does
Automatically reduces printouts at variable rates down to a
Auto
minimum of 50%. Tries to reduce printout to fit on one sheet of
your selected paper size. If it can’t, print the image at 100% size
on two or more pages.
100%
Does not reduce documents. (Due to the sender’s TTI , this may print
two pages when receiving a one-page fax document.)
Reduction margin
Your machine’s reduction margin is measured in millimeters (mm). We’ll define
reduction margin by explaining how it’s used:
When a fax message enters your machine’s electronic brain, the machine measures
the message’s length and compares it to (a) the length of your selected paper (not
include the print margins) plus (b) the reduction margin you set. If the length of
the incoming message is shorter than (a) and (b) put together, your machine prints
the message on just one sheet.
If it’s longer, your machine prints the message on more than one sheet.
Note: An Auto reduction setting and a reduction margin setting of 24 mm will
print most incoming faxes as single pages. Try this combination first and
then, only if you have problems with it, select different settings.
Half-page reception
Half-page reception can conserve paper if some of the faxes you receive are half-
page, “memo-sized” messages. When activated, this feature tells the machine to
combine two of these half-page receptions onto a single sheet. Half-page reception
only combines half-page messages sent back-to-back during the same transmission.
It won’t combine two half-page faxes from separate transmissions.
To adjust the print settings
Default setting: Rx reduction rate: Auto, Reduction margin: 24 mm,
Half-page reception: Off
1 Press Program key, B , 2, 0, 2, ENTER . The LCD shows the current print
reduction rate:
2 Press or until the reduction setting you want appears.
In this example, we’ve chosen 100%.
3 Press ENTER to save the setting. The LCD shows the current reduction margin:
4 Use the numeric keypad to enter the reduction margin you want. If
necessary, press
or to move the cursor. In this example, we’ve chosen
38mm.
5 Press ENTER to save the setting. The LCD shows the current setting for
half-page reception:
Half Page Recpt.:Off

/

/Enter
Margin
(00-85mm):38
Margin
(00-85mm):24
Rx Reduc.Rate :100%

/

/Enter
Rx Reduc.Rate :Auto
 /  /Enter
Changing the default settings
4.3
Settings for reception