Konica Minolta 7013 - Manual (Page 96)

Advanced features
Programming printouts
To program a programmable one-touch key to print a list:
1 Press Program key, A , 3, 0, 1, ENTER . The LCD shows the first empty pro-
grammable one-touch number available:
Note: If P2 appears on the LCD , it means that you have already entered a
number for P1. You can see what you programmed into P1 by press-
ing , if you want. For example, if you set P1 for printing a list of the
machine settings, you will see:
Press to go back to the programmable one-touch key you want to
enter.
Note: To erase a programmable one-touch key, see page 3.48.
2 Press the key that you want to program or change. Here, we’ve selected P2.
Note: If your previous command for this key was for printing a list and you
want to keep this key programmed for printing a list, use these
instructions to make changes. But if you want to assign this key to a
completely different operation (for a delayed transmission, for exam-
ple), then you first must erase the stored command before
programming the new one.
3 If you want to select a different programmable one-touch key than the one
that appears on the
LCD , press that key now.
4 Press ENTER . The LCD asks which operation you want to program into the pro-
grammable one-touch:
Note: If changing a previously stored command, skip to step 7.
5 Press until “List Print” appears.
6 Press ENTER . The LCD asks which list you want to program into the program-
mable one-touch:
7 Press until the list you want appears.
8 Press ENTER .
9 Press STOP to return your machine to standby mode.
P2:Machine Settings

/

/Enter
Type :List Print

/

/Enter
Type :Communication
 /  /Enter
Select Program No.
P2:No Number Stored
Select Program No.
P1:Machine Settings
Select Program No.
P2:No Number Stored
3.45