Konica Minolta 7013 - Manual (Page 79)

Advanced features
21 Enter the fax number using a one-touch key, a speed-dial number or a call
group number. You cannot use the numeric keypad to enter these numbers.
To add each fax number, press BROADCAST between each one to insert a
comma, then enter the number. You can specify up to 200 numbers for a
remote unit.
22 Press ENTER to save the settings. The LCD shows:
The machine asks for the type of TTI you want to appear on the faxes that are
relayed to other callers.
• Sender — Relay the document with sender unit’s
TTI (don’t send your TTI ).
• Both — Relay the document with both the sender unit’s TTI and your TTI .
• Yours — Relay the document with your TTI instead of the sender unit’s.
Press or until the mode you want appears.
23 Press ENTER to save the settings. The LCD shows:
On: Print the document automatically when it’s received.
Off: The machine does not print it, but only relays it to the other machine.
Press or until the mode you want appears.
Then press ENTER to save the settings and go on to step 24.
24 The machine asks for your F-Code box’s four-digit security I . D . code. This is
the I . D . code for the box’s security, which you use to (1) print a document any
remote F-Code-compatible fax sends to this F-Code box or (2) you enter before
you can make any changes to this F-Code box.
If you do not want to change the I . D . code, skip to step 27.
25 Decide on a four-digit I . D . code (0001-9999) for this F-Code box.
Write it down, and put it in a safe place.
Important: Do not use 0000 as an I . D . code.
26 Use the numeric keypad to enter the four-digit I . D . code for this F-Code box.
Important: After completing this step, you must know this code to print
documents sent to this F-Code box. Be sure to write it down.
27 Press ENTER to save the F-Code box information.
To create or modify another F-Code box, repeat steps 3-27.
To finish, press
STOP .
Printing a list of F-Code boxes
The list of F-Code boxes includes:
(1) Each box’s identifier number
(2) Box name (if any)
(3) Sub-address
(4) Password
(5) Box type
(6) Each box’s settings
To print a list of your F-Code boxes, press Program key, E , 1, 1, 3, ENTER .
Printing a list of documents stored in your F-Code boxes
The list of documents stored in your machine’s F-Code boxes includes:
(1) Each box’s identifier number
(2) Box name (if any)
(3) Box type
(4) Each file number (or document number) that is stored
To print a list of documents stored in F-Code boxes, press Program key, E , 1, 1, 4,
ENTER .
03:Set F-Code Box
Enter I.D. Code:0000
Auto Print :Off

/

/Enter
Select TTI :Sender
 /  /Enter
Enter Relay Number
S001,G12_
3.28