Konica Minolta 7013 - Manual (Page 126)

Just in case …
Occasionally, your fax machine encounters some trouble transmitting or receiving
documents. When it does, it alerts you with an alarm. You can identify the problem
with
LCD messages and printed check messages and error reports, explained in the
following pages.
Alarm
Your fax machine sounds an alarm tone — a series of short beeps — if either of
these two problems occur:
• Trouble transmitting or receiving
• The machine is out of paper
LCD error messages
What you see on the LCD What it means/What to do
All Commands In Use Your fax machine has all of its 99 possible
delayed commands (automatic redialing counts
as one) stored in memory and cannot accept
another. Wait until your fax has completed one of
the delayed commands or delete an existing
command by using
COMM . CANCEL / CONFIRM .
Already Stored You tried to enter the same fax (or phone) num-
ber which is already entered in your fax
machine.
Enter a different fax (or phone) number.
Box In Use You tried to erase a F-Code box which contains
at least one document.
Erase the document(s), then try again.
Call For Service The scanner lamp is dim or inoperable.
Make repeated copies to help evaporate any
internal moisture. If that doesn’t resolve the
problem, call your authorised Konica dealer.
What you see on the LCD What it means/What to do
Change to Fax Mode You tried to to store the document for polling (or
for F-Code Box) when the machine is in the
Copy mode. You can store the fax document only
when the machine is in the Fax mode.
Check Memory Tx You tried to turn the Fax&Copy feature ON , but
the memory transmission setting is OFF . To use
the Fax&Copy feature, the memory transmis-
sion setting must be set to
ON .
Set the Memory Tx to ON , then try again.
Check Paper Size The different sized paper which is not same
Open&Close Top Cover sized paper you told your machine is loaded.
Set correct sized paper or change the paper size
setting (see pages 1.8–1.10).
Close Scanner Cover The cover indicated on the LCD is open or has
Close Top Cover
not been closed securely. Close it properly.
Close 1st Side Cover
Close 2nd Side Cover
Close 1st Cassette The paper cassette indicated on the LCD is open
Close 2nd Cassette or has not been closed securely. Close it properly.
Communication Error A communication error disrupted the reception
or transmission. If you were transmitting, press
STOP to clear the error message and then re-try
the transmission. If you were receiving a fax, try
to contact the other person and have him/her re-
try the transmission. (The problem may be
entirely with his/her machine, phone line, etc.)
Copy Off You tried to change your fax machine to the copy
mode, but the unit’s copy protection feature
(page 2.17) is on, preventing such use. Turn off
copy protection.
Department Code Full You tried to enter department code more than
100. Your machine can store up to 100 depart-
ment codes.
5.5
Troubleshooting