KORG MICROX X50 - Manual (Page 139)

132
a: BPM, b: L Bs, b: Times, c: C Bs, c: Times, d: R Bs, d: Times
The delay time is the length of the note obtained by multiplying
the “Bs” parameter by the Times value, in relation to the tempo
specified by the “BPM” parameter (or the MIDI Clock tempo if
“BPM” is set to MIDI).
f: Time Over? >
You can set the delay time up to 1365msec. If the delay time
exceeds this limit, the error message “OVER!” appears in the dis-
play. Set the delay time parameters so that this message will not
appear. “Time Over?>” is only a display parameter.
50: St.BPM Delay
(Stereo BPM Delay)
This stereo delay enables you to set the delay time to match
the song tempo.
f: Time Over? L >, f: R >
You can set the delay time up to 682msec. If the delay time
exceeds this limit, the error message “OVER!” appears in the dis-
play. Set the delay time parameters so that this message will not
appear. “Time Over?>” is only a display parameter.
51: Sequence Dly
(Sequence Delay)
This four-tap delay enables you to select a tempo and rhythm
pattern to set up each tap.
h
InLvl Mod (Input Level Dmod [%]) –100...+100
Sets the modulation amount of the input level ☞ Fx:37,
Src (Source)
Selects the modulation source for the input level Off...Tempo
☞ Fx:37
i
Spread 0...50
Sets the width of the stereo image of the effect sound ☞ Fx:43
j
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
a
BPM MIDI, 40...240
Selects MIDI Clock and assigns tempo ☞ Fx:49,
b
L Bs (L Delay Base Note)
Selects the type of notes to specify the left channel delay time
☞ Fx:49,
Times 1...16
Sets the number of notes to specify the left channel delay time
☞ Fx:49
Adj (Adjust)
Fine-adjust the left channel delay time –2.50...+2.50%
c
R Bs (R Delay Base Note)
Selects the type of notes to specify the right channel delay time
☞ Fx:49,
Times 1...16
Sets the number of notes to specify the right channel delay time
☞ Fx:49
Adj (Adjust)
Fine-adjust the right channel delay time –2.50...+2.50%
d
L Fb (L Feedback)
Sets the feedback amount for the left channel –100...+100
(Source) Off...Tempo
Selects the modulation source of feedback amount
(Amount L) –100...+100
Sets the modulation amount of the left channel feedback
e
R Fb (R Feedback)
Sets the feedback amount for the right channel –100...+100
(Amount R) –100...+100
Sets the modulation amount of the right channel feedback
Left
Right
Feedback
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Input Level D-mod
Input Level D-mod
High Damp Low Damp
High Damp Low Damp
Tempo
BPM
BPM Base Note x Times
Base Note x Times
Adjust [%]
Adjust [%]
Delay
Delay
f
Time Over? L > ----, OVER!
Display the error message if the left channel delay time exceeds the
upper limit
☞
R > ----, OVER!
Display the error message if the right channel delay time exceeds the
upper limit
☞
g
HiDamp (High Damp)
Sets the damping amount in the high range 0...100%
☞ Fx:43
LoDamp (Low Damp)
Sets the damping amount in the low range 0...100%
☞ Fx:43
h
InLvl Mod (Input Level Mod [%]) –100...+100
Sets the modulation amount of the input level ☞ Fx:37,
Src (Source)
Selects the modulation source for the input level Off...Tempo
☞ Fx:37
i
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
a
BPM
Selects MIDI Clock and assigns tempo MIDI, 44...240
☞ ,
Rhythm (Rhythm Pattern)
Selects a rhythm pattern – – – ... 3
☞ ,
b
Tap1 Pan
Sets the panning of Tap1 L, 1...99, R
c
Tap2 Pan
Sets the panning of Tap2 L, 1...99, R
d
Tap3 Pan
Sets the panning of Tap3 L, 1...99, R
e
Tap4 Pan
Sets the panning of Tap4 L, 1...99, R
f
Fb (Feedback)
Sets the feedback amount –100...+100
(Source) Off...Tempo
Selects the modulation source of feedback amount
(Amount)
Sets the modulation amount of the feedback –100...+100
g
HiDamp (High Damp)
Sets the damping amount in the high range 0...100%
☞ Fx:43
LoDamp (Low Damp)
Sets the damping amount in the low range 0...100%
☞ Fx:43
Delay
Left
Right
Feedback
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Input Level D-mod
High Damp Low Damp
Input Level D-mod
+
Tempo
BPM
BPM
Rythm Pattern
Pan