KORG MICROX X50 - Manual (Page 87)

80
microX: Ext. Control Setup [Off, On]
This protects the external control set memory of the microX.
On (checked):
The external control set memory of the
microX will be protected, and the following writing opera-
tions will not be possible.
• Writing an external control set
• Receiving external control set data via MIDI data
dump
Off (unchecked): External control memory sets can be writ-
ten to the microX.
■ 0–2: UTILITY
☞“Write Global Setting,” “Load Preload Data,” “Change all
bank references,” “Half Damper Calibration” (0–1)
0–3: Foot
Specify the polarity and function of a switch or pedal con-
nected to the rear panel.
0–3a: Damper/Assignable Foot Switch,
Pedal
Foot SW Assign [Off...Tap Tempo]
Select the function that will be controlled by a pedal switch
(PS-1 option [sold separately]) connected to the rear panel
ASSIGNABLE SWITCH jack (
☞p.164 “Foot Switch Assign
List”).
Foot Pedal Assign [Off...Knob4]
Indicates the function that will be controlled by a foot vol-
ume pedal (XVP-10 or EXP-2 option [sold separately]) con-
nected to the rear panel ASSIGNABLE PEDAL jack (
☞p.165
“Foot Pedal Assign List”).
Damper Polarity [(–) KORG Standard, (+)]
Set this to match the polarity of the damper pedal connected
to the rear panel DAMPER jack.
If a Korg DS-1H (sold separately) damper pedal is con-
nected, the pedal switch polarity will be (
↓), so select “(–)
KORG Standard ” for this setting. If you have connected a
damper pedal with a positive ( ↑) polarity, select “(+)” for
this setting. ( ↓ is open-type, ↑ is closed-type.) If the polarity
does not match, operating the damper pedal will not pro-
duce the correct result. If no damper pedal is connected, set
this to “(–) KORG Standard.”
Foot Switch Polarity [(–) KORG Standard, (+)]
Set this to match the polarity of the pedal switch connected
to the rear panel ASSIGNABLE SWITCH jack.
If a Korg PS-1 (sold separately) pedal switch is connected,
the pedal switch polarity will be (
↓), so select “(–) KORG
Standard ” for this setting. If you have connected a pedal
switch with a positive ( ↑) polarity, select “(+)” for this set-
ting. ( ↓ is open-type, ↑ is closed-type.) If the polarity does
not match, operating the pedal switch will not produce the
correct result. If no pedal switch is connected, set this to “(–)
KORG Standard
.”
■ 0–3: UTILITY
☞“Write Global Setting,” “Load Preload Data,” “Change all
bank references,” “Half Damper Calibration” (0–1)
0–3a