Lantronix XPORT PROTM 900-560 User Manual
Page 45
6: Line and Tunnel Settings
XPort Pro User Guide
45
5.
Click Submit.
6.
Repeat above steps as desired, according to additional tunnel(s) available on your product.
Flush Serial Data
Select Enabled to flush the serial data buffer on a new connection.
Block Serial Data
Select On to block, or not tunnel, serial data transmitted to the
device.
Block Network
Select On to block, or not tunnel, network data transmitted to the
device.
Password
Enter a password that clients must send to the device within 30 seconds from
opening a network connection to enable data transmission.
The password can have up to 31 characters and must contain only alphanumeric
characters and punctuation. When set, the password sent to the device must be
terminated with one of the following: (a) 0x0A (LF), (b) 0x00, (c) 0x0D 0x0A (CR
LF), or (d) 0x0D 0x00.
Email on Connect
Select whether the device sends an email when a connection is made. Select
None if you do not want to send an email. Otherwise, select the Email profile to
use for sending.
Email on Disconnect
Select whether the device sends an email when a connection is closed. Select
None if you do not want to send an email. Otherwise, select the Email profile to
use for sending.
CP Output
Identifies a CP or CP Group whose value should change when a connection is
established and dropped.
Connection value—Specifies the value to set the CP Group to when a
connection is established.
Disconnection value—Specifies the value to set the CP Group to when the
connection is closed.
Tunnel - Accept Mode
Settings (continued)
Description